Isodyne is a manufacturer of EMI back shells utilizing a patented system consisting of a heat treated stainless steel spring band to secure the over braid to the back shell. Combined with a slot in the banding area allowing 100% contact between the back shell and the drain wires, creating a direct path to ground with very low resistance levels increasing EMI performance. Here are some of the benefits of the Isodyne Tool Less Braid Termination System No tools required for assembly or dis-assembly Available for Series 38999 I-IV, 83723 Series I-III, 26482, 5015, customs Typical resistance levels: 0.3m Ohm/Shield to back shell, 0.6m Ohm/gross over braid to back shell * Our customers have told us that under vibration the resistance levels go lower as the band tightens Circular back shells available in straight, 45° & 90° versions D-Subs, Micro D-Subs, ARINC, Splice Kits, Bulkhead Mount & Jam Nuts also available Holding force exceeds 125 ft lbs of force Isodynes patented slots eliminates the need for solder sleeves